Articles via Databases
Articles via Journals
Online Catalog
E-books
Research & Information Literacy
Interlibrary loan
Theses & Dissertations
Collections
Policies
Services
About / Contact Us
Administration
Littman Architecture Library
This site will be removed in January 2019, please change your bookmarks.
This page will redirect to https://digitalcommons.njit.edu/dissertations/1106 in 5 seconds

The New Jersey Institute of Technology's
Electronic Theses & Dissertations Project

Title: Micromechanics of hot mix asphalt material formulation and numerical simulation
Author: Chang, Kuo-Neng G.
View Online: njit-etd1995-036
(xv, 182 pages ~ 5.3 MB pdf)
Department: Department of Civil and Environmental Engineering
Degree: Doctor of Philosophy
Program: Civil Engineering
Document Type: Dissertation
Advisory Committee: Meegoda, Jay N. (Committee chair)
Khera, Raj P. (Committee member)
Raghu, Dorairaja (Committee member)
Luke, Jonathan H.C. (Committee member)
Rosato, Anthony D. (Committee member)
Date: 1995-05
Keywords: Micromechanics.
Asphalt.
Pavements, Asphalt.
Availability: Unrestricted
Abstract:

Hot Mix Asphalt (HMA), a highway and airfield pavement material, is heterogeneous, granular, and composite. It is traditionally modeled as a homogeneous material using continuum mechanics or semi-empirical methods. As a result, the above models either neglect or over-simply component reactions, failing to predict field performance problems resulting from particle segregation. This research presents micromechanical modeling, a novel approach that accounts for the components.

A micromechanical model is developed for HMA by modeling it as an assembly of asphalt cement coated particles. The asphalt cement is modeled as a viscoelastic material. To represent asphalt cement, several viscoelastic elements (i.e. Maxwell, Kelvin-Voigt, and Burgers' elements) were considered. From these viscoelastic elements the Burgers' element is shown to be most representative of asphalt binder behavior based on mechanical responses and comparisons with physical experimental results.

The model for HMA, ASBAL, is based on the TRUBAL program, a Discrete Element Method (DEM), with Burgers' element. Monotonic and cyclic tests were simulated to observe the ability of the model to predict the mechanical behavior of HMA. During these simulations the physical values of microscopic input parameters were varied to determine how each contributes to the overall behavior of HMA.

Then, the ASBAL model was used to simulate a mechanical test with x-ray tomography to accurately predict residual stresses of the laboratory sample after compaction, the initial modulus, stress levels throughout the test, and number of contacts within HMA matrix.

Using the master curve and the time-temperature superposition theory the input parameters for the Burgers' element at different temperatures were calculated. Using those input parameters, the mechanical responses of HMA at different temperatures were simulated. Results show that at higher temperatures the strength and initial stiffness values are a fraction of those found at lower temperatures. Hence the ASBAL model predicts the temperature softening of HMA that contributes to the rutting of HMA. The micromechanical model simulates the discrete mechanical behavior of HMA and hence can be used to develop performance based tests for HMA.


If you have any questions please contact the ETD Team, libetd@njit.edu.

 
ETD Information
Digital Commons @ NJIT
Theses and DIssertations
ETD Policies & Procedures
ETD FAQ's
ETD home

Request a Scan
NDLTD

NJIT's ETD project was given an ACRL/NJ Technology Innovation Honorable Mention Award in spring 2003