Articles via Databases
Articles via Journals
Online Catalog
E-books
Research & Information Literacy
Interlibrary loan
Theses & Dissertations
Collections
Policies
Services
About / Contact Us
Administration
Littman Architecture Library
This site will be removed in January 2019, please change your bookmarks.
This page will redirect to https://digitalcommons.njit.edu/theses/1239 in 5 seconds

The New Jersey Institute of Technology's
Electronic Theses & Dissertations Project

Title: Fluid flow modeling for pneumatically fractured formations
Author: Nautiyal, Deepak
View Online: njit-etd1994-051
(xiv, 133 pages ~ 5.2 MB pdf)
Department: Department of Civil and Environmental Engineering
Degree: Master of Science
Program: Environmental Engineering
Document Type: Thesis
Advisory Committee: Schuring, John R. (Committee chair)
Chan, Paul C. (Committee member)
Shaw, Earl David (Committee member)
Date: 1994-01
Keywords: Pneumatic control--Models.
Fracture mechanics--Environmental aspects.
Pneumatics--Environmental aspects.
Availability: Unrestricted
Abstract:

This thesis investigates the flow of compressible fluids in pneumatically fractured formations. Pneumatic fracturing is a recently developed technique for increasing permeability in geologic formations by the controlled injection of high pressure air. The artificially induced fractures enhance the flow rate of liquids and vapors in the subsurface, and can be applied to in situ remediation of hazardous waste sites, and for other hydrogeological applications.

A flow model for discrete fractures is derived based on the assumptions of viscous, laminar fluid flow through planar fractures (Poiseuille type flow). The model takes into account non-linearity introduced by gas compressibility effects. Provision is also made for turbulent conditions which can result from high flow velocity and/or surface roughness of fractures. The model is presented in both linear and radial flow formats.

Model validation is accomplished by analyzing pressure and flow data from a siltstone formation which had been pneumatically fractured in the vadose zone. Air flows were observed to increase from a baseline of 0.3-0.4 SCFM before fracturing, to 4.0-71 SCFM after fracturing. Using this model, the total equivalent (single) aperture for the 8.4 ft. test zone was found to increase from 86 microns in the prefracture condition, to 516 microns in the postfracture condition. Analysis of fracture flow velocities and associated Reynolds numbers indicated that although laminar flow conditions exist in natural fracture networks, some degree of turbulence may be encountered in pneumatically induced fractures owing to aperture enlargement.

Detailed study of borehole video tapes of the fracture well indicated the principal mechanism of flow enhancement was aperture dilation of existing natural fractures, and improvement of fracture connectivity. A minor amount of new horizontal and vertical fractures were also noted. Statistical analysis of the video also indicated an improvement in flow uniformity along the borehole profile, as a result of fracturing. A physical model of the fracture zone is presented which is useful for analysis of contaminant mass transport in the formation, especially applications involving molecular diffusion, heat transfer, and biodegradation processes.


If you have any questions please contact the ETD Team, libetd@njit.edu.

 
ETD Information
Digital Commons @ NJIT
Theses and DIssertations
ETD Policies & Procedures
ETD FAQ's
ETD home

Request a Scan
NDLTD

NJIT's ETD project was given an ACRL/NJ Technology Innovation Honorable Mention Award in spring 2003